Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Round Hill, VA

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Round Hill, VA?

Select your specific project to find the pro for you.

TRUSTED BY ROUND HILL, VA HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon139
    Verified drywall insulation services reviews

Find Drywall insulation pros in Round Hill

Avatar for Comfenergy, LLC
Comfenergy, LLC
4.6(
54
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Round Hill, VA and surrounding areas

Approved

In business since 2011

Free estimates

Warranties offered

"From initial contact with their sales department we've had a great experience, Corey did an excellent job of taking pictures and showing the problems in our attic. Their level of communication from emails to phone calls was precisely correct by contacting me when needed and not too much with pictures detailing each solution and its associated cost. On the first work day their crew called ahead of time, arrived promptly and came prepared with masks, plastic sheeting, full body outfits and cloth covering for the stairs. In just over 6 hours they had cleaned up the entire attic removing bad sub-floor and other insulation, laid out the foundation for building a large deck space and placed part of the first layer of materials down. They also sealed the attic door along with some of the air vents and ceiling fans. They completed insulating my front porch overhang and cleaned up all of their mess very well. Painters tape was used on corners where they we’re most likely to bump into it for protection and plastic sheeting was setup precisely where needed to keep dust off of our hallway things next to the attic entrance. Overall it was a great first day and they even spotted an issue from a previous vendor who failed to properly connect some of their duct work together (which was the original cause of my daughter’s room temperature being so hard to control the temperature and not easy to spot). The only complaint I have is that while I fully expected the need to finish our attic sub-floor, remaining layers of TruSoftTM Cellulose on the main floor and encapsulate the duct lines with Polyurethane Spray Foam all before finishing with blown-in insulation, they left a key piece incomplete. When leaving they left the duct work leading from our main trunk line to my daughter’s room off. This left a hole in the main trunk line reducing heat in all upstairs rooms but most important is that nothing was connected to my daughter’s room. So around 6:00am she woke up coughing as we noticed the upstairs was around 56 degrees. Overall a simple heads up would have solved everything as we have space heaters, however I did not look into the attic when they left so that’s my fault for not knowing a key piece of the duct line was missing. Based on the overall work complete I would still very much recommend them as Robert (onsite team lead) was very good at communicating and the crew we’re all quite friendly. Their work will last for the lifetime of my house and has already added value to the sale price. In the end they made a really nice attic deck leaving me with plenty of useable storage space. While this is not the cheapest company, the quality and knowledge that I never need to worry about my attic again is certainly worth it."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+68

Response time1 day
Response rate100%
34 neighbors recently requested a quote
Avatar for HomeGuard Foam & Foundation
HomeGuard Foam & Foundation
4.4(
25
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Round Hill, VA and surrounding areas

Approved

In business since 2020

Free estimates

Warranties offered

"I had several options to pursue in finding a remedy for my hot attic. After meeting with the insulation consultant who was extremely knowledgeable, patient, and provided detailed explanations of how to insulate I knew proceeding with the job was the right decision. My attic is noticeably cooler and I highly recommend"
Attic - Open Cell Spray Foam
Closed Cell Spray Foam
Open Cell on Exterior Walls
Open Cell Spray Foam
Open Cell Spray Foam

+76

Response time1 day
Response rate88%
22 neighbors recently requested a quote
Avatar for Discount Energy Services
Discount Energy Services
4.3(
89
)
Blown-In Insulation - Install or UpgradeInsulation - Install or Upgrade

Serving Round Hill, VA and surrounding areas

Approved

In business since 1984

Free estimates

Warranties offered

"After my call to Discount Energy Services, I knew who was coming and when to evaluate my attic insulation. The estimate was prepared on-site with pricing. The workers arrived and knew exactly what they were to accomplish, which they confirmed with me. They prepared the entire path with clean drop cloths and created a plastic drape around my attic stairs. The foreman was glad to explain any aspect of the procedure. My attic was upgraded to R-49 and the difference is notable."
Additional Photos
.
.
.
.

+2

Response time7 hrs
Response rate100%
22 neighbors recently requested a quote
Avatar for The Fifth Fuel of Virginia, LLC
The Fifth Fuel of Virginia, LLC
4.6(
59
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Round Hill, VA and surrounding areas

Approved

In business since 2012

Free estimates

Credit card accepted

"After researching and obtaining quotes from a number of companies, I selected The Fifth Fuel to air seal and insulate my attic (blown-in cellulose), cantilevers, and rim-joist. From the initial consultation with Adam to email follow-up, the project and my options were clearly explained. When I asked about putting a higher R-value in my attic, Adam provided the price but explained why it didn't make sense for me. I appreciated that he didn't try to oversell me. The proposal laid out everything they would be doing. The cost was reasonable. It wasn't the lowest bid, but was less than 50% of some other bids. The day of installation, the crew arrived a bit early. Throughout the install they were professional, kind, and clean. They protected the inside and outside of our house and vacuumed afterward. They conducted a blower door test at the end to quantify the difference made by air sealing. Within two hours of them leaving, we've already noticed a difference in our comfort and our A/C is not even running half the time it was before."
Response time1 day
4 neighbors recently requested a quote
Recommended by90%of homeowners
Avatar for Comfenergy
Comfenergy
3.9(
50
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Round Hill, VA and surrounding areas

Approved

In business since 2013

Free estimates

Warranties offered

"From the start of the estimate with Jon to the insulation project with the Team Leader Carlos, the project went well as expected. Jon was very professional and knowledgeable. He did not try to up-sale services I did not need, and I appreciate his honesty. Jon went over the appropriate insulation for the attic and the garage ceiling to bring our home to a comfortable level. Carlos and his crew did a great job communicating with me while performing the insulation. Carlos immediately notified me of a leak he discovered from the attic fan and temporarily paused the work on the attic and moved to the garage ceiling insulation while I addressed the leak. As a customer, the only comments/suggestions I would give to the crew is: (1) make sure they keep their tools and materials off the lawn (2) make sure the plastic wraps from the materials they use and trash does not get blown away to the neighbor's yard/driveway, and finally, (3) ask the homeowner which bathroom the crew can use while on-site. Overall, I am very happy with Comfenergy and their service. In fact, I have already recommended them to a curious neighbor."
Attic before
Attic after
Historic Waterford Home
Historic Plaque
Crawl space before

+6

Response time1 day
112 neighbors recently requested a quote
Recommended by84%of homeowners
Avatar for ROI Construction LLC
ROI Construction LLC
4.1(
18
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Round Hill, VA and surrounding areas

Approved

In business since 1974

Free estimates

Warranties offered

"We had a great experience with ROI Construction sales representative David Burke. David was very knowledgeable about ROI's porducts and services. We look forward to getting our attic insulation project completed and will provide a more thorough review at that time. Thanks, Tim"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+19

55 neighbors recently requested a quote
Recommended by90%of homeowners
...
Showing 1-10 of 80
Drywall Insulation questions, answered by experts

Plastering and skimming are two different techniques for finishing walls. Plastering involves applying a thick layer of a plaster mixture—typically containing gypsum, lime, cement, sand, and water—to create a new surface. This process often requires multiple coats and is used for repairing significant damage or creating decorative textures. Skimming, on the other hand, is a technique that involves applying a thin layer of drywall compound or joint compound over an existing surface to smooth it out, covering minor imperfections, small cracks, or uneven textures for a polished look. Plastering is generally more costly and labor-intensive than skimming. Although some people use the terms interchangeably, they refer to different processes and materials.

The time it takes for thinset to dry is determined by your room’s ambient temperature and humidity levels. Assuming the average humidity level is around 40% with an average temperature of 70 degrees Fahrenheit, thinset can dry within 48 hours. Lower temperatures and higher humidity can extend the curing process beyond 72 hours, while high heat and zero humidity can shorten the curing process. However, thinset can crack if it dries too fast.

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Ceiling-mounted curtains won’t damage the ceiling if they’re installed properly. Using the right anchors or securing the brackets into joists will ensure the curtain weight is properly supported and prevent damage. However, overtightening screws, using weak anchors, or repeatedly removing and reinstalling hardware in the same spot can cause cracking or sagging over time. In that case, you might have to call a pro for ceiling repair.

Yes, you can mount a TV on plaster walls—as long as you attach it to the studs. Alternatively, you can use toggle bolts, molly bolts, or another type of hardware that’s strong enough to support a TV. 

If you aren’t comfortable with this type of project, you can hire a pro. The cost of mounting a TV to a plaster wall ranges from $25 to $600 (or more), depending on the TV’s weight, size, and other factors.

The Round Hill, VA homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.