Get matched with top pressure washers in Covington, VA

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.

Deciding whether to buy or rent a pressure washer depends on your budget and how often you plan to use it.

• Renting: The daily rental cost typically ranges from $40 to $175. Renting can be more cost-effective for a one-time project.

• Buying: The purchase price for a pressure washer can range from $100 to over $1,000. More specifically, electric models generally cost between $100 and $400, while gas models run from $300 to $600.

If you anticipate using a pressure washer multiple times a year, buying one is often a better long-term investment. When purchasing, remember that a higher-quality machine will likely deliver better and more reliable results.

Not pressure washing your driveway can lead to several consequences that affect both its appearance and its structural integrity over time:  

• Reduced Curb Appeal: A dirty driveway covered in grime, stains, and mildew detracts from your home's overall appearance.  

• Safety Hazards: The buildup of algae, moss, and mildew creates slippery surfaces. When wet, it increases the risk of slips and falls for you, your family, and visitors.  

• Structural Damage: Dirt, debris, and organic growth can trap moisture against the driveway's surface. In colder climates, this moisture can freeze and thaw, leading to cracks and deterioration of the concrete or asphalt.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.