Top-rated well and pump technicians.

Best well and pump technicians near Aneth, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Aneth, UT?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Aneth - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Aneth, UT and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps FAQs, answered by experts

The average lifespan of a deep well pump is between 15 and 25 years, after which you’ll have to replace it. Several factors can affect the lifespan of a well pump, such as the quality of the unit. Proper maintenance and repair can also help extend your well pump’s lifespan as well as keep adequate water flow and pressure throughout your home.

Every 1-2 years to ensure optimal performance and prolong lifespan.

Why is my irrigation pump not pulling water?

There are a few reasons your irrigation pump isn’t pulling in water. You could have a clogged suction filter. You may have not properly primed your pump so air got stuck somewhere in the system. Your pump also won’t work properly if it has faulty or damaged pump components, like a pump motor or pressure switch.

Reduced water pressure, strange noises, or air sputtering from faucets.

Yes, you can shock a well yourself, but it can be dangerous if you don’t know what you’re doing. We recommend calling a pro, but if you decide to do it yourself, make sure to follow proper safety precautions. This means wearing the correct safety gear, such as rubber gloves, goggles, and boots. You should also mix the chlorine solution in an open area with plenty of ventilation. Also, make sure not to drink or use the water for a few days afterward, until you’ve flushed the system and retested the water.

The Aneth, UT homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.