Top-rated well and pump technicians.

Get matched with top well and pump technicians in Upper Fruitland, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Upper Fruitland, NM?

Select your specific project to find the pro for you.

Find Well and pump technicians in Upper Fruitland

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Upper Fruitland, NM and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps questions, answered by experts

Common problems include low water pressure, no water, and strange noises. Regular maintenance prevents many issues.

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

There are many reasons you may want to extend the depth of an existing well or drill a new, deeper well on your property. A deeper well can tap cleaner water sources—shallow water may contain more contaminants. With a deeper well, you’ll also have an easier time reaching the water table depth (the level at which underground water is found) and can get past tricky soil conditions. 

Plus, if your local building code requires a minimum well depth for safety and environmental standards, you’ll meet the code by digging a deeper well in the first place.

You should check water pressure twice a year to ensure there aren’t any irregularities and that it isn’t too high. It’s also smart to check it any time you notice symptoms of high water pressure (like banging pipes, inconsistent water flow, and leaky fixtures). Similarly, if you live in an area that’s prone to water pressure fluctuations due to municipal supply changes, elevation, or seasonal temperature shifts, check it more frequently. You can buy an affordable water pressure gauge and check the water pressure yourself.

No. Well pump replacement is not recommended as a DIY project, particularly if you have a deep well and a submersible pump. Plumbing and electricity are best left to the pros, especially when something like your well pump includes both. Even when troubleshooting your pump, it pays to have a partner standing by for your assistance and safety.

The Upper Fruitland, NM homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.