Best pool and spa technicians near Conroe, TX

Hot tubs don’t necessarily add value to a home—but they don’t take it away either. It depends on the potential buyer. A well-landscaped in-ground hot tub is attractive to buyers who prioritize relaxation and fun. Others would rather not deal with the maintenance. 

In most cases, it is safe to clean a hot tub with vinegar. You will want to verify that your hot tub manufacturer lists vinegar as a safe cleaning product; however, given that vinegar is chemical-free, cleans, deodorizes, and is safe for people and pets, it is usually a good option. You can use vinegar to clean the hot tub shell, interior and exterior spa surfaces, hot tub jets, hot tub filter, and other parts. It is considered a strong, safe, and natural cleanser that can kill bacteria, remove mold and mildew spores, erase water spots, and remove hard water stains.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.