Get matched with top above ground pool installation pros in Winner, SD

Yes, you can put too much shock in a pool, and it is crucial to follow the directions on the product you are using. Adding excess shock can upset the chemical balance, make the water cloudy, have adverse effects on swimmers, damage pool equipment or surfaces, and even encourage certain types of algae to grow. If you have over-shocked your pool, perform a water test and adjust the chemicals as necessary. The pool's chemical balance will eventually return to normal as the excess chlorine dissipates over time.

Sometimes, homeowners choose to install their pool on concrete, foam tiles, or patio pavers. Leveled dirt is also fine, as long as it’s not sod or grass. Regardless, you’ll need to install sand as a buffer to prevent your liner from tearing. Some pool installers also use a protective foam pool pad.

Shipping container pools are prone to rust and corrosion over time, especially if you install a saltwater system. Though the interior of your pool should be lined, the outside is at risk. Luckily there are a few things you can do.

Elevate your pool or place it on a foundation to prevent moisture buildup along the bottom of the container. Apply a rust inhibitor or paint to protect the outside of your pool, and maintain the proper chlorine levels to reduce the rate of corrosion. Regularly inspect your pool for signs of corrosion, and take action when necessary. 

You should add chlorine within 48 hours of filling your pool with water. In just 24 hours, bacteria and algae will begin to grow and contaminate your water. After that point, you’ll need to shock the water with high levels of chlorine, and you’ll likely need to do additional vacuuming to get the pool clean. It’s important to check your chlorine levels two to three times a week and add more chlorine as needed to maintain a healthy level.