Top-rated sump pump installation pros.

Get matched with top sump pump installation pros in Sioux Falls, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your sump pump installation project in Sioux Falls, SD?

Select your specific project to find the pro for you.

TRUSTED BY SIOUX FALLS, SD HOMEOWNERS

  • Average homeowner rating star icon4.3
    Average homeowner rating
  • Verified reviews icon313
    Verified sump pump installation services reviews

Find Sump pump installation pros in Sioux Falls

Avatar for Groundworks
Groundworks
4.3(
247
)
Sump Pump or Interior Foundation Drains - InstallSump Pump - Repair or Replace

Serving Sioux Falls, SD and surrounding areas

Approved (Corporate)

In business since 2005

Free estimates

Warranties offered

"It was installation of a sump pump. Craig, Tyler and a third gentleman whose name I canâ t remember were great. Arrived on time, did a wonderful job, were professional and answered all my questions. I highly recommend them. Took only a day and a half from start to finish."
Foundation
Basement Waterproofing
Basement Waterproofing
Basement Waterproofing
Basement Waterproofing

+16

152 neighbors recently requested a quote
Recommended by88%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Sump Pump - Repair or ReplaceSump Pump or Interior Foundation Drains - Install

Serving Sioux Falls, SD and surrounding areas

In business since 1971

Credit card accepted

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Sump Pump Installation questions, answered by experts

Every three to four months, you should clean any dirt and debris off of your sump pump. You should also check the inlet screen (at the bottom of the pump) to make sure that it isn’t blocked. On top of that, you should deep clean your sump pump once per year—or hire a sump pump pro to do it for you.

There are several indicators that your washing machine’s drain pump is bad, including incomplete cycles, water not draining, lack of spinning, a foul odor when the machine is running, and a loud grinding or buzzing noise when the pump is trying to move water down the drain.

A sump pump can be plugged into a regular, 110-volt outlet with three-prong openings, but it must have GFCI protections per the NEC, meaning you’ll need a GFCI outlet and circuit. Sump pumps require two outlet openings, one for the plug to the motor and one for the float switch.

You should be fine. Most high-grade grinder pumps have a 24-hour holding capacity within the tank. You can continue to use the facilities so long as the power outage does not stretch into days. In a worst-case scenario, attach a generator to the grinder pump, providing it has sufficient electric capacity.

First, you can try unplugging the two sump pump cords, one for the motor and one for the float switch, then plugging them back in to reset the sump pump. You can also reset the sump pump by turning it off and back on at the breaker. Many sump pumps have a reset button, which you can press and hold for a few seconds to reset the device.

The Sioux Falls, SD homeowners’ guide to sump pump installation services

From average costs to expert advice, get all the answers you need to get your job done.