Get matched with top electricians in Little Rock, SC

By nature, two-prong outlets aren't grounded—but the box they run to might be, which makes them safer. The safest way to test if an outlet is grounded is to purchase a circuit tester, which cost about $20 at home improvement stores. 

If you discover your outlet (or outlets) aren't grounded, know that this greatly increases your risk of personal injury and electrical fires. You may want to consider installing new three-prong ground fault circuit interrupter (GFCI) outlets. On average, the cost to install GFCI outlets is about $210 per outlet.

Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.

A circuit breaker flipping off when it detects an overloaded circuit isn’t a problem, but flipping the switch frequently can damage it and eventually cause an electrical hazard. If you’re going on a long vacation or leaving your home for the season, you should avoid turning off your circuit breaker to prevent electrical damage to your system.

If there isn’t a C-wire on your thermostat, you can repurpose the G-wire. The G-wire controls the fan independently of the other controls on your thermostat, so the fan-only function won’t work if you decide to go this route.