A 3-prong, 15-amp, 120-volt outlet is standard in the U.S. These have two vertical slots and a U-shaped grounding hole, which suits most home electronics, from televisions to microwaves. Three-pronged outlets are safer than 2-pronged ones, as the third wire, known as the grounding wire, helps prevent shocks and electrical fires.

A home electrical inspection usually takes one to two hours. Full home inspections fall on the longer side, while code compliance inspections that focus on a single repair or installation may only take a few minutes. Optional add-ons like infrared inspections can add time, but these aren’t usually included in your standard inspection.

According to the National Electrical Code (NEC), GFCI outlets should be installed in wet or damp locations where they might be splashed with water or other liquids. This is to protect against ground faults, which are more common around water. Specific areas that require GFCI outlets include kitchens (especially near counters), bathrooms, laundry rooms, basements, garages, and all outdoor receptacles. Depending on local electrical codes, you may need at least one GFCI outlet in these rooms, or every outlet in the area may need to be GFCI protected.

It can be safe to buy or live in a house with knob and tube (K&T) wiring, but only if the system is in good condition, functional, and has been thoroughly inspected and approved by a licensed electrician. Never purchase a home with K&T wiring without getting a professional electrical inspection first.

Key considerations include:

• Safety and Condition: An inspector will verify that the wiring is safe and has not deteriorated. Over time, the insulation can wear away, leaving exposed wires that pose a significant fire or shock hazard.

• System Capacity: The electrical service should be at least 60 amps. However, even at this capacity, K&T systems often struggle to handle the demands of modern appliances and electronics.

• Lack of Grounding: Knob and tube wiring is an ungrounded system, which is a safety concern for many modern devices.

• Ongoing Maintenance: If you live in a home with K&T wiring, it's recommended to have it inspected by an electrician every one to two years to ensure it remains in safe working order.

Ultimately, any inspection or modification of a knob and tube system should always be performed by a certified professional.