Top-rated electricians.

Get matched with top electricians in Gibson, NC

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Gibson, NC?

Select your specific project to find the pro for you.

TRUSTED BY GIBSON, NC HOMEOWNERS

  • Average homeowner rating star icon4.8
    Average homeowner rating
  • Verified reviews icon40
    Verified electrical services reviews

Find Electricians in Gibson

Avatar for W B Lightning Rods
W B Lightning Rods
4.6(
367
)
Lightning Protection - Install or Repair

Serving Gibson, NC and surrounding areas

Approved

In business since 2001

Free estimates

Warranties offered

"We have been hit twice by lightning by God's grace either one hit our home however the last strike burnt art motorhome to the ground William was hired to install lightning protection lightning rods on our home and two out buildings he took the time to explain to us everything we needed to know answering every question professionally conducted himself in the utmost professional manner I would highly recommend lightning rods and even more highly recommended hiring William to do the job we are going to do an expansion later on and he will be the one and only contractor I will call to continue our lightning protection"
lightning protection
 Residential LPS
lightning protection
 Residential LPS
lightning protection

+79

Response time1 day
81 neighbors recently requested a quote
Recommended by98%of homeowners
M&D Property Solutions
4.5(
23
)
Appliance (Major Electric Appliance) - Install or Replace

Serving Gibson, NC and surrounding areas

Approved

In business since 2017

Emergency services offered

Warranties offered

"Needed fencing installed to keep groundhogs from taking up residence under our deck. Brady came up with a creative and complete solution that made sure the varmints were out and would not return. Would use again."
Master bedroom
Master bedroom
Front hall
Living area
Entry

+10

Response time1 day
2 neighbors recently requested a quote
Recommended by100%of homeowners
...
Showing 1-10 of 113
Electrical questions, answered by experts

An average, 400-square-foot electric heated driveways consume approximately $3 per hour in terms of electricity. The price may slightly fluctuate depending on your local energy cost. A simple formula to calculate your heated driveway’s total wattage consumption is by multiplying the square footage by 50 watts and then dividing it by 1,000 to get the kilowatt number. Multiply that with your local energy cost per hour and there you have the hourly operating cost.

Call your utility company immediately. Do not go outside, even in your own yard, and keep pets indoors. Downed power lines pose a serious electrocution hazard. They can also cause large power surges that could damage your appliances, so it’s a good idea to shut down power to your home if possible. If your breakers trip, leave them off until the utility company finishes its repair work.

While circuit breakers are designed to be reset after tripping, there isn't a strict countdown to when they will fail. The primary danger lies in a breaker tripping multiple times in a short period without allowing the components to cool down. Theoretically, a standard breaker might handle around 50 trips caused by simple overloading. However, this number can be much lower in practice. For instance, a high-current fault could damage a breaker to the point that it needs replacement after only two resets. Repeatedly resetting a breaker that trips frequently exacerbates the underlying problem by causing the electrical components, wires, and the breaker itself to overheat. This can lead to permanent damage, cause the breaker to trip unnecessarily in the future, and increase the risk of an electrical fire. If a breaker trips every few minutes, you should leave it in the 'off' position and call a qualified electrician for an inspection.

Yes, you can get shocked while using a multimeter if:

  • You touch the metal tip while testing a live current.

  • The meter isn’t properly rated for the voltage.

  • The meter picks up on transient voltage that’s above the range you’ve set.

  • The meter has defective parts.

You can prevent shock and personal injury by using a multimeter properly and maintaining your device. 

If you’re unsure how to use a multimeter or want help with your project, contact a local electrician to get the job done.

Yes, you can put a dimmer on a three-way switch, but it can’t be the same kind of dimmer you’d put on a standard light switch. A three-way switch requires a three-way dimmer. If two switches control a single or multiple lights, then you need a three-way dimmer. The type of light bulb should also be compatible with your fixture and dimmer.

The Gibson, NC homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.