Top-rated electricians.

Best electricians near Boiling Springs, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Boiling Springs, PA?

Select your specific project to find the pro for you.

TRUSTED BY BOILING SPRINGS, PA HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon974
    Verified electrical services reviews

Top-Rated Electricians in Boiling Springs - Updated Nov 2026

Avatar for Rittner's Electric
Rittner's Electric
4.9(
187
)
Electric Vehicle Charging Station Installation - Materials Not ProvidedElectrical Switches, Outlets & Fixtures - Install or RepairElectrical Wiring or Panel Upgrade+13 more

Serving Boiling Springs, PA and surrounding areas

Approved

In business since 1995

Free estimates

Emergency services offered

"Dave is a master of his trade. He is highly communicative, knowledgeable, and professional. He replaced an existing 100-amp electrical panel with a new 100-amp panel and installed new circuit breakers. Throughout the project, he provided valuable information and took the time to answer our questions. We would not hesitate to use Rittner's Electric again and highly recommend them to anyone in need of electrical services."
Response time7 hrs
Response rate100%
3 neighbors recently requested a quote
Avatar for BHI Installations
BHI Installations
4.8(
131
)
Appliance (Major Electric Appliance) - Install or Replace

Serving Boiling Springs, PA and surrounding areas

Approved

In business since 2002

Free estimates

Credit card accepted

"Billy installed my ceiling fan in under a half an hour. He was very professional, and very personable. I WILL be contracting Billy again to install an outlet in my kitchen, and will contract him in the future for any of my electrical needs."
Response time40 mins
6 neighbors recently requested a quote
Recommended by98%of homeowners
Avatar for W B Lightning Rods
W B Lightning Rods
4.6(
372
)
Lightning Protection - Install or Repair

Serving Boiling Springs, PA and surrounding areas

Approved

In business since 2001

Free estimates

Warranties offered

"WB Lightning is focused on customer service. The company provided good communication and responded very quickly to my inquiry for a quote. WB Lightning is a respected company, I had another electrical service provider tell me I made a good choice when I hired WB Lightning Rods."
lightning protection
 Residential LPS
lightning protection
 Residential LPS
lightning protection

+79

Response time1 day
127 neighbors recently requested a quote
Recommended by96%of homeowners
...
Showing 1-10 of 313
Electrical FAQs, answered by experts

Volts and watts aren’t directly convertible units—they measure different aspects of electricity. Volts measure electrical potential, while watts quantify the power. The relationship between the two is defined by the equation: Power (watts)= Voltage (volts) x Current (amperes). In other words, the product of volts and amps results in watts, but there is no fixed conversion of volts into watts.

While washers and dryers do not require a GFCI (ground fault circuit interrupter) outlet to function properly, electrical codes often mandate their use for safety. The National Electrical Code (NEC) requires GFCI protection for all outlets within six feet of a water source. This means a washer and dryer must be plugged into a GFCI outlet if they are installed in locations like a laundry room, utility room, garage, or basement. In other areas without a nearby water source, there is no specific requirement, but using a GFCI outlet is still recommended for extra peace of mind. It is always best to consult your local codes and regulations to ensure compliance and safety.

That depends on your setup. If a circuit breaker already has GFCI protection, then everything connected to that specific circuit is being monitored. You don’t need additional GFCI outlets on that breaker.

However, if the breaker is not GFCI, then you should have GFCI receptacles for at-risk outlets nearby water sources, because they are not receiving protection. Breakers in a breaker box can vary between GFCI and non-GFCI. Look for GFCI labels on the breaker or try to find the breaker model number to look it up if you aren’t sure.

Knowing if and when your circuit breaker is failing or faulty can prevent costly damage. If you notice any of the following signs, call a local electrician to help. 

  • The breaker frequently trips

  • The breaker doesn't stay in the 'on' position or reset properly

  • You hear buzzing or humming noises coming from the breaker

  • There's discoloration around the breaker switch

  • There's a burning smell or visible signs of damage on the breaker

The copper wire used in knob and tube wiring systems can last up to 100 years. However, it’s considered a dangerous and outdated wiring method because the cloth, fabric, or rubber insulation sheathing can become brittle and fall apart. Knob and tube wiring systems should be inspected if you’re considering buying a home with this type of wiring, or if you have problems with frequently tripping breakers, a sign that you may need to replace them.

The Boiling Springs, PA homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.