Get matched with top sump pump installation pros in Bakerstown, PA

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to move wastewater and solid waste to the municipal sewer or septic tank. However, for fixtures located below grade (e.g., in a basement), gravity is not sufficient.

The purpose of a sewage ejector pump is to actively pump this wastewater and solid waste upward into the main sewer line. Without an ejector pump in this situation, wastewater would have no way to exit and would eventually back up, causing a sewage overflow or flooding in your basement. If all of your home's plumbing is on the main floor or higher, gravity can handle the drainage, and an ejector pump is not needed.

A sump pump can be plugged into a regular, 110-volt outlet with three-prong openings, but it must have GFCI protections per the NEC, meaning you’ll need a GFCI outlet and circuit. Sump pumps require two outlet openings, one for the plug to the motor and one for the float switch.

A sump pump's lifespan is typically 7 to 10 years, though the general range can be anywhere from 5 to 15 years. The specific type of pump is a major factor: pedestal sump pumps last an average of 20 to 25 years, whereas submersible sump pumps last between 5 and 15 years. While pedestal pumps are less expensive to service, they are also louder and more prone to clogging.

Several other factors influence longevity, including the pump's quality, usage frequency, and maintenance schedule. A high-quality pump that is well-maintained in a dry climate may last for two decades, while a lower-quality, poorly maintained pump in an area with a high water table or frequent flooding may fail in six years or less.

Regular maintenance, including annual inspections and tuneups from a professional, can significantly extend the pump's life. It is time to consider a replacement if your sump pump runs constantly, cycles frequently, shows visible rust or corrosion, or trips a circuit breaker. As a preventative measure, many homeowners replace their pumps every eight years. It's also worth noting that a manufacturer's warranty can indicate expected lifespan, and some home insurance policies may not cover water damage from a pump that is past its recommended replacement date.

A small sump pump running infrequently uses an average of 10 kilowatt-hours (kWh) of electricity per month. The average cost for electricity is $0.171 per kWh. The size and use frequency affect how much electricity it uses. Sump pumps average one-third to one horsepower (hp) motors. One hp is equal to 745.7 watts. Watts multiplied by the time your pump is running divided by 1,000 equals your average kWh. Multiply kWh by your average cost of electricity. In areas with high rain or a marsh basin, the average cost can be as high as $15-$25 a month.