Top-rated structural engineers.

Get matched with top structural engineers in Independence, OR

Enter your zip and get matched with up to 5 pros

Need a pro for your structural engineering project in Independence, OR?

Select your specific project to find the pro for you.

Find Structural engineers in Independence

Tim Wilkinson-Engineering
5.0(
3
)

Serving Independence, OR and surrounding areas

Approved

In business since 2009

Free estimates

Offers commercial services

Wilkinson Engineering, LLC is a Consulting Engineering firm based in Portland, Oregon offering services in the field of structural engineering including complex design, owner representation, value engineering, feasibility studies, investigations, finite element analysis, peer review and forensic analysis for commercial and residential clients. Our firm also offers unique design services in the areas of renovation/rehabilitation, preservation of historical structures, due diligence reports, seismic evaluations and other special projects including LEED Platinum and ecoroofs.\n\nOur mission is to provide superior professional services and we deliver by ensuring each project receives continuous personal attention. Our commitment to delivering sound, creative engineering conveyed through clear concise documents within budget and on schedule is assured through the Principal's involvement in every project to ensure timely and competent direction.

17 neighbors recently requested a quote
Recommended by100%of homeowners
Structural Engineering questions, answered by experts

A freestanding brick wall that's only one brick thick can usually stand six to eight feet high. If you need a higher wall, it should be at least two bricks thick for adequate stability, and it might require a footing to support the added weight. Additionally, some areas have regulations and codes dictating how high a brick wall can be, so check with local code enforcers to ensure your proposed wall complies with any regulations.

Through proper drainage solutions and compacting the foundation soil.

Yes. Foundation walls are always load-bearing.

The 10 10 rule describes the formula most contractors use to determine how much to charge for a job. Allowing for 10% overhead above the total projected cost to do the work and 10% profit sets a contractor up for success, even if there are delays or other problems on the project. This formula isn’t a hard-and-fast rule, but it is a ballpark figure to begin with when estimating your expenses on a job.

First, most contractors will have a structural engineer create a report and plan for your project to ensure it’s safe to cut into the load-bearing wall. The contractor will then excavate around the wall, if necessary, measure the opening—allowing for additional space to fit and level the door, and then cut the doorway out. They will likely install a steel lintel as a header over the door for support. Once the doorway is cut out, they’ll demolish the concrete using sledge hammers and masonry chisels, clean up the surrounding concrete, and seal around the door with masonry mortar. 

The Independence, OR homeowners’ guide to structural engineering services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"