Get matched with top door pros in Independence, OR

Yes, barn doors can be too heavy, although the limitation is usually imposed by the mounting hardware you buy and not your home’s framing, unless you’re building an unusually wide door. To keep the weight down, you can opt for 1-by material rather than 2-by material, and choose a softwood like pine rather than a hardwood like maple or oak. Check the weight limits on your mounting hardware, and always attach your door track to studs rather than to drywall anchors.

The best direction for a gate to swing depends on its location and purpose, but swinging inward is the general rule. An inward swing is often considered safer, prevents the gate from opening into public spaces like a sidewalk, and may be required by local building codes.

There are exceptions and specific considerations. If your property is on a slope, an inward swing might not be possible. For a deck gate, it's safest to have it swing away from any steps. In a backyard, the direction can be a matter of preference, though an inward swing can be helpful when carrying heavy items like a wheelbarrow into a garden.

Regardless of direction, ensure the gate can open fully without hitting any objects or blocking spaces. While an inward swing is standard, a gate that can swing both in and out offers the most flexibility if your setup allows for it.

On average, sliding glass patio doors can last between 20 and 30 years. Their actual lifespan depends on several factors, including proper installation, frequency of use, and regular maintenance of the sliding components. While this is the typical range, minor problems and the need for occasional repairs or part replacements can still occur. Addressing issues as soon as they arise and performing regular maintenance will help extend the door's life. If the door is older and requires frequent or significant repairs, it may be more cost-effective to replace the entire unit.

You should generally cut between 1/8-inch and 1 inch when planing a door. If you cut off more than that, you risk damaging the door. Planing too much from the bottom of your door can cause noticeable gaps, so it’s always better to start with as thin of a section as possible and work in thin layers until your door no longer sticks.