Get matched with top drywall pros in Condon, OR

There is no way to cut drywall without making dust, but you can reduce the amount of dust and especially the dangerous airborne particles by using manual cutting tools. Using a utility knife to score and snap your drywall will minimize dust production, and a jab saw for cutting cutouts for boxes and fixtures will generate almost no airborne dust. Even if you use these methods, you should still wear a respirator and safety goggles to avoid damage to your lungs and eyes.

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.

Two of the biggest mistakes with drywalling are not measuring (and therefore buying the wrong amount of drywall) and trying to install drywall yourself. A sheet of drywall can weigh around 50 pounds, so it can be difficult to install without a pro or at least some experienced friends willing to help with a DIY installation. It can also get expensive if you don’t measure at least twice before buying the drywall sheets.

Drywall does not necessarily need to be glued to the ceiling, especially when it is properly screwed or nailed into place. Drywall is typically attached to the ceiling joists using screws or nails, ensuring a secure and stable drywall installation. 

However, in certain situations where additional adhesion is required, construction adhesive can be applied in combination with screws or nails. This is often done for ceilings with specific acoustic or insulation requirements. It's essential to follow local building codes and best practices to determine if adhesive use is necessary for your specific project.