Best countertop and backsplash pros near Thomas, OK

Countertop resurfacing or refinishing can extend the life of your countertops for an additional 5 to 10 years. The longevity depends on the quality of the materials, the amount of wear and tear, and how well the countertops are maintained. To maximize their lifespan, avoid heat damage by using hot pads or trivets, use cutting boards to prevent scratches, clean with non-abrasive cleaners, and wipe up spills promptly.

The frequency for sealing granite countertops depends on several factors, including the type of sealant used, the color of the granite, and how heavily the countertops are used. As a general guideline, resealing is often recommended every 12 to 18 months, but some sources suggest it could be as often as every few months or at least once a year.

The type of sealant is a major factor: water-based sealants may need reapplication every six months to a year, while more durable solvent-based sealants can last for five to 10 years. Additionally, factors like heavy kitchen traffic, frequent use of acidic cleaners, and lighter granite colors may require more frequent sealing to prevent staining.

To determine if your countertops need resealing, you can perform a simple water test. Place a few drops of water or a wet paper towel on an inconspicuous area of the granite. After 10 to 15 minutes, check the spot. If the water has beaded up, the seal is still intact. If the water has been absorbed and darkened the stone, it's time to apply a new coat of sealant. You can choose to seal the granite yourself or hire a professional to ensure it's done correctly.

Yes, you can install a new layer of laminate over an existing laminate countertop, which can save you time and money while updating its appearance. The process is similar to installing laminate directly onto particle board. First, clean the existing countertop thoroughly. Next, fill and sand any cracks or damaged areas. Then, you'll need to sand or scratch up the entire surface to help the contact cement or glue adhere properly. After applying the adhesive, you can install the new laminate layer on top. If you're looking for other ways to improve your existing laminate countertops, you could also consider painting them or applying an epoxy finish.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.