Get matched with top countertop and backsplash pros in Okarche, OK

Yes, laminate (or Formica) countertops often come in precut sizes. It is important to measure your space and then do some research, or take the measurements to a local home improvement store to see if you can get the right size. If you do get precut laminate countertops, you may still have to cut holes for the sink and fixtures.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

It all comes down to rarity and demand. Granite rocks with unique patterns or rare colorways like red, purple, and blue are more expensive than traditional designs. Some types of blue granite are extremely rare, like Azul Aran and Blue Bahia, driving the price up even further. The most expensive type of all is a unique design called Van Gogh granite. As the name suggests, it sort of looks like a painting. 

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.