Get matched with top roofers in Bokoshe, OK

The most common defect in a flat roof is leaking. Flat roofs have minimal slope, so water pools more readily on a flat roof than on a sloped roof, and the risk of the waterproof membrane failing increases with exposure. Tears and punctures from foot traffic and blown debris are other common problems, especially with single-ply roofing membranes like TPO and EPDM roofs.

A roof replacement can take anywhere from one to 14 days. For most homes, a full replacement that includes tearing off old materials takes about one to two days, though the average project can last up to 12 days. The exact timeline depends on several factors, including the roof's size and complexity, the type of roofing material, the crew size, and weather conditions. Certain materials take longer to install; for example, metal roofs can take seven to 14 days because the material is more difficult to work with than asphalt shingles, wood, or tile. A re-roofing project, where new shingles are installed over old ones, can take half the time or less. It's also important to factor in the time needed to obtain necessary permits. A professional roofing contractor will typically complete the job faster than a DIY approach.

Yes, removing a chimney is a difficult and major undertaking. Chimneys often provide structural support to a home, so if it's a load-bearing structure, you'll need to take extra precautions to maintain your home's integrity. A project of this complexity typically requires a structural engineer, a masonry contractor, and a demolition crew. The removal process may involve taking the chimney out brick by brick from inside the walls. The cost for chimney removal can range from $2,000 to $10,000, depending on the job's complexity. Due to the difficulty and cost, some homeowners opt to remove the fireplace and seal the chimney at the top and bottom, sometimes also removing the visible exterior portion at the roofline.

Underlayment is required by building code, so any roof installed without it is technically against code. The underlayment acts as the second layer of defense against water, so installing a roof without underlayment means a much higher risk of roof leaks. You’ll have the best chance of avoiding roof leaks if you install drip edge flashing covered by underlayment, and then install your roofing material over that.