Get matched with top garage pros in Lima, OH

Garage floor sealers last anywhere from one to 10 years on average, depending on the type of sealer you use and the traffic it’s exposed to. Acrylic sealers have the shortest longevity, whereas most other options can last anywhere from five to 10 years. If you use an acrylic sealant to protect against stains, reapply every one to two years. Reapply other types of concrete sealers every five years for the best results and maximum protection.

The most common garage door material is aluminum, but the best material for you depends on your budget and location. Wood is the most expensive to repair but tends to add the most curb appeal, while fiberglass or composite doors cost less to fix.

Aluminum won’t rust, so it’s a great option if you live somewhere humid or rainy. Steel doors are durable but are prone to rust. If you live somewhere with extreme temperatures, hot or cold, you might opt for fiberglass, which won’t split if the temperatures skyrocket or drop below freezing.

No, there should not be a gap between your garage door and the floor. Gaps can make your garage less energy efficient, leading to higher energy bills. They also create an entry point for pests like rodents and insects, as well as rain and melted snow, which can lead to foundation damage or mold issues.

If you have a gap under your garage door, potential causes include an uneven garage floor or worn-out weather stripping. To fix it, you can try several solutions:

• Replace the weather stripping: The seal at the bottom of the door may need to be replaced.

• Adjust the garage door: You may be able to adjust the closing position on your garage door opener to eliminate the gap.

• Inspect the floor: If the concrete floor has shifted or is uneven, it may need to be repaired to create a level surface.

If these solutions do not resolve the issue, it is best to call a garage door repair specialist to inspect the door and floor.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.