Get matched with top roofers in Carey, OH

Generally, hailstones that are one inch in diameter or larger can cause significant damage to a roof. However, smaller hail can also cause damage, particularly when accompanied by strong winds, if it strikes an aging or poorly maintained roof, or if hailstorms are frequent in your area. Hail that is ¼ inch (pea-sized) or smaller poses a minimal risk of immediate, permanent damage, but cumulative impacts can cause deterioration over time. The extent of the damage also depends on the roofing material; hail-resistant tiles like slate or certain types of asphalt shingles can withstand impacts better than other materials. If you are concerned about potential damage after a storm, it is always a good idea to have a professional roofer conduct an inspection.

Complete house winterization goes above and beyond the list we created above. In addition to everything listed, full house winterization also includes:

• Performing a home energy audit.

• Preparing your deck and patio for winter.

• Learning how to start a snowblower.

• Replacing smoke detector batteries.

• Installing outlet gaskets.

• Installing storm doors.  

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Most roof leaks occur where shingles meet or where there are sealants or seams in the materials. This is common around skylights and at any point there is a break in the roof such as corners and edges. Roofing materials are incredibly strong and resistant when overlapping, but any change in that can cause gaps where water can enter.