Top-rated toilet pros.

Get matched with top toilet pros in Pelham, NY

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Pelham, NY?

Select your specific project to find the pro for you.

TRUSTED BY PELHAM, NY HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon1.6k+
    Verified toilet services reviews

Find Toilet pros in Pelham

Clear Pro Sewer & Drain
4.9(
97
)
Drain Clog or Blockage - Clear

Serving Pelham, NY and surrounding areas

Approved

In business since 2000

Free estimates

Emergency services offered

"Jason arrived both on time and actually early for the appointment. He handled himself and the job professionally - clearing the master shower drain and another bathtub drain setting. I would recommend him without hesitation and will plan to use his services in the future as needed."
Response time50 mins
1 neighbors recently requested a quote
Recommended by98%of homeowners
...
Showing 1-10 of 574
Toilets questions, answered by experts

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

If you have to hold the toilet handle (also called the toilet lever) down to flush, you probably have a chain problem. A chain that cannot fully lift the flapper will close too early and not clear the toilet bowl. Try adjusting the chain length so there’s about ½ inch of slack.   

A gurgling toilet usually doesn’t mean that your septic tank is full. If waste can’t drain into a full septic tank, you’ll see water and sewage backing up into your fixtures, but the air that causes gurgling is a result of poor venting. You are more likely to have a clog in your vent stack or a damaged air admittance valve.

This rumbling noise after flushing may sound like a hammer or knocking inside the walls. When you flush, it opens a valve so additional water can come in. However, if the valve malfunctions, then this rush of water has nowhere to go, which makes all the excess water hit your pipes and create a loud hammering sound.

Replacing a standard toilet with an elongated one is straightforward. The two types can be installed using the same existing drainpipe and plumbing. If you have a small bathroom, make sure that an elongated toilet doesn’t violate local building codes for clearance, which is the space between fixtures and walls. 

The Pelham, NY homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.