Get matched with top electricians in Tohatchi, NM
Top-rated electricians.

Need a pro for your electrical service project in Tohatchi, NM?

Select your specific project to find the pro for you.

Find Electricians in Tohatchi

Avatar for Red, White, and Blue Lightning Protection
Red, White, and Blue Lightning Protection
4.7(
78
)

Serving Tohatchi, NM and surrounding areas

In business since 1970

Free estimates

"My house was under construction. and had already gotten struck by lightning so time was critical as I knew it could happen again. I have a home with tall roof peaks and built on a hill. They came out quickly and started right away and their prices were way less than the other company s. I will use them again when my barn is constructed."
Lightning rod system
Lightning rod system
Lightning rod residential
Lightning rod residential
Lightning rod residential

+5

Response time4 hrs
Recommended by100%of homeowners
Avatar for Defined Electric
Defined Electric
5.0(
1
)

Serving Tohatchi, NM and surrounding areas

In business since 2005

Emergency services offered

Warranties offered

"So impressed with his immediate response, then problem solving with me through photos and outlet testing without requiring $ up front, prior to completion of job. Very knowledgeable and continuously responsive! Will post more once job complete, but am very impressed so far!"
Additional Photos
Additional Photos
Additional Photos
Showing 1-10 of 35
Electrical questions, answered by experts

Yes, one wire is always hot on the 3-way switch, meaning it carries the electricity from the power source to the switch. If you have a 3-wire cable in your home, you have two hot wires, or line wires, coming from the power source. Typically, you’d connect the hot black wire from the power source to the traveler wire and the hot red wire from the power source to the first 3-way switch. For the second 3-way switch, you’d then connect the hot black traveler wire to the switch.

GFCI stands for ground fault circuit interrupter, which means it has the ability to detect a ground fault and shut the circuit down before it creates hazards. General breakers may also do that because ground faults can cause overloads, but they’re more focused on amp overloads from any cause. GFCIs are often installed in specific outlets, but breakers can come with GFCI capabilities built in for broader ground fault protection.

Daisy-chaining refers to placing multiple GFCI outlets in a row along the same circuit. This won’t do any harm, but it’s of limited usefulness because a properly-placed GFCI can monitor all downstream outlets on its own. Multiple GFCI installations won’t usually increase safety except in special cases.

Thankfully, LED lights use less electricity than incandescent lights, meaning you won’t spend as much on utility bills by using these light strips. Each 5-meter LED light strip will cost about $3 per year on your energy bill.

According to the National Electrical Code® (NEC®), the electrical code for kitchen outlets states that electrical outlets in a kitchen should be installed no more than 48 inches apart. This ensures that a receptacle is no further away than 24 inches from any place on the countertop. Countertops wider than 12 inches need an outlet on the wall above the countertop.

The Tohatchi, NM homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.