Get matched with top concrete resurfacing pros in Prewitt, NM

No, hairline cracks in concrete are generally not a problem as they do not impact the strength and longevity of the concrete. Generally, cracks less than 0.3 millimeter wide don’t impact the structure. Hairline cracks can grow over time and weaken the structure, such as in a home foundation. Some hairline cracks can also cause leaks in a foundation. It’s important to watch the cracks to see if they grow. Contact a concrete contractor if you notice cracks exceeding 0.3 millimeter wide.

Whether resurfacing concrete is worth the cost depends on the condition of the underlying slab. Resurfacing can be a good option if the concrete is in decent condition with only minor issues like standard wear and tear, small cracks, chips, or discoloration. In these cases, resurfacing adds a protective layer that can extend the concrete's lifespan without the high cost of a full replacement.

However, if the concrete has significant damage—such as deep cracks, peeling, sinking, or is broken up—resurfacing may not be worth it. The new overlay is only as good as the concrete beneath it, and existing problems like peeling and cracks are likely to show through the new surface. In situations with severe damage, replacing the entire slab is often more cost-effective in the long run and will yield a better result.

To make the best decision, it's recommended to have a licensed concrete specialist inspect the damage and determine if resurfacing is the right choice for your situation.

If your concrete steps have crumbled or chipped, you can fix them by removing any chips or flakes, cleaning and wetting the affected area, applying a concrete bonding agent, and finally applying new concrete, usually in the form of Portland cement. For widespread damage, you can consider concrete resurfacing instead. For fixing concrete spalling that has led to deep damage, you might need to remove damaged material, add structural supports, and pour new concrete into a mold.

Concrete resurfacing is the process of applying a new, thin layer of concrete over an existing concrete slab to enhance its appearance and durability. The terms 'concrete resurfacing' and 'concrete overlay' are often used interchangeably, though the exact meaning can vary between contractors. Generally, both refer to applying a layer of pre-blended concrete, typically between 1/4-inch and 1-inch thick. Some contractors may use 'overlay' to describe a thicker application that adds structural integrity, while 'resurfacing' might refer to a thinner, more cosmetic layer. This process is a cost-effective alternative to completely replacing the concrete, as it uses significantly less material than pouring a new 4-inch slab. Resurfacing also provides an opportunity to add new colors or stamped textures. Other names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.