Get matched with top concrete resurfacing pros in Portales, NM

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.

Mudjacking is suitable for sidewalks, driveways, patios, and nearly all exterior flat structures. However, it may not suit severely damaged or heavily cracked areas.

Concrete shrinkage cracks are very common and should be expected. Even professionals end up with shrinkage cracks on newly poured concrete slabs. Remember that these cracks are not harmful to the slab's strength, though some homeowners do prefer to fill in the cracks for aesthetics. When installing concrete, you can avoid ample concrete shrinkage cracks by avoiding hot, sunny, or windy days.