Get matched with top concrete resurfacing pros in Melrose, NM

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.

The easiest way to handle extra-wet cement is to pour it, let it harden, and then recycle it using one of the methods above. You can also crush it down and sell it for base materials, although this can be pretty time-consuming. Your best bet is to start with less concrete than you need and make more as you go to avoid this problem.

You can dry pour concrete over existing concrete, but it’s best to use wet pour concrete instead. Dry pour concrete is easier to apply, but in order for new concrete to adhere to old concrete, it needs the right mixture for slow, uniform curing. Additionally, dry pour concrete is less durable and less resistant to cracking and concrete sinking, so dry pouring over an existing slab may result in surface imperfections appearing prematurely.

You'll find a slurry of natural and synthetic polymers, rubbers, epoxies, and resins used to bond old concrete to new concrete. The right bonding agent depends on the method of concrete pouring you choose and whether you're adhering concrete over concrete or concrete over sand and gravel. Some concrete resurfacing mixtures contain bonding chemicals as well.