Best concrete resurfacing pros near Texico, NM

Whether resurfacing concrete is worth the cost depends on the condition of the underlying slab. Resurfacing can be a good option if the concrete is in decent condition with only minor issues like standard wear and tear, small cracks, chips, or discoloration. In these cases, resurfacing adds a protective layer that can extend the concrete's lifespan without the high cost of a full replacement.

However, if the concrete has significant damage—such as deep cracks, peeling, sinking, or is broken up—resurfacing may not be worth it. The new overlay is only as good as the concrete beneath it, and existing problems like peeling and cracks are likely to show through the new surface. In situations with severe damage, replacing the entire slab is often more cost-effective in the long run and will yield a better result.

To make the best decision, it's recommended to have a licensed concrete specialist inspect the damage and determine if resurfacing is the right choice for your situation.

You have different options depending on the scale of repair needed. If you are repairing minor cracks that are between ¼ inch to 1.5 inch wide and less than half an inch deep, a self-leveling polyurethane sealant would be your best choice. Polyurethane sealants dry to the touch within one to two hours. Since they come in a tube applier, you also have the option to complete the repair without emptying out your garage.

If there is standing liquid on your concrete, remove it before attempting any of the above cleaning methods. For small amounts of water, use rags, a bucket, and a mop. For larger areas of liquid, lay down cat litter or baking soda to soak up the water first. If you have extremely large pools of water sitting on your concrete, break out the wet vac and get to work.

You can dry pour concrete over existing concrete, but it’s best to use wet pour concrete instead. Dry pour concrete is easier to apply, but in order for new concrete to adhere to old concrete, it needs the right mixture for slow, uniform curing. Additionally, dry pour concrete is less durable and less resistant to cracking and concrete sinking, so dry pouring over an existing slab may result in surface imperfections appearing prematurely.