Get matched with top floor polishers in Polvadera, NM

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Regular sealing, proper drainage, and periodic inspections prevent premature wear and cracking.