Top-rated toilet pros.

Get matched with top toilet pros in Hershey, NE

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Hershey, NE?

Select your specific project to find the pro for you.

TRUSTED BY HERSHEY, NE HOMEOWNERS

  • Average homeowner rating star icon4.2
    Average homeowner rating
  • Verified reviews icon54
    Verified toilet services reviews

Find Toilet pros in Hershey

Burns Construction
0.0(
2
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Hershey, NE and surrounding areas

In business since 2000

Free estimates

Burns Construction, is a full service general contracting firm operating in the greater SW NE area for many years. We pride ourselves in our attention to detail and our unsurpassed customer service. The quality of our work speaks for itself and we look forward to working with you on your next project.

Recommended by100%of homeowners
Toilets questions, answered by experts

Yes, frozen pipes can cause a toilet to stop working correctly. If the pipes are frozen, water cannot flow, which can lead to two main problems. First, the supply line to the toilet tank may be frozen, which prevents the tank from refilling with water after you flush. Second, the drain pipe itself can freeze, blocking water from flushing away. As a temporary solution for a non-refilling tank, you can manually add water, but this is not a long-term fix. To clear a frozen drain pipe, you can try pouring warm water into the toilet bowl or tank and then flushing, as the warm water may help thaw the ice blockage. Ultimately, the best course of action is to unfreeze the affected pipes to restore your toilet to full functionality.

On average, it costs between $150 and $300 to fix a toilet that’s leaking at the base, including supply charges. If the flange is intact, the cost is between $150 to $200. If the flange needs to be replaced, you can expect an extra $50 or so. The actual price will depend on the hourly rate your plumber charges.

Toilet handles can get stuck for a couple of reasons, but it’s commonly an issue with the chain. Remove the lid and check the chain’s connection, running from the flapper to the handle arm. Sometimes the chain gets snagged on or against another part of the tank. 

The chain might not have the right tension. For example, a chain that’s too short can make the handle feel stuck. Check that there’s some slack in the chain. Old, worn-out flappers can get stuck, too. In this case, you’ll need to see which size toilet flapper you need.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

The Hershey, NE homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.