Get matched with top toilet pros in Chappell, NE

Even though they’re modern-looking, easier to clean, can be hung at any height, and help save space compared to traditional toilets, wall-hung toilets have some downsides. They’re more expensive than standard toilets, sometimes by a few hundred dollars. They’re also difficult to install and may require major plumbing work to reroute the drain if the previous toilet was a floor-mount model.

This tight fit can make repairs more difficult. You’ll also have to consider where you can hang them and weight limit restrictions, so they may not be the best fit for every home.

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

Yes, you can pour water down the toilet to help it flush. For each flush, you’ll need 1 to 2 gallons of water for newer toilets or 3 to 5 gallons of water for older toilets. Rather than dumping the entire bucket in all at once, pour the water in slowly for the best results. If you’re pouring water down the toilet to help it flush after a clog, only use 1 gallon of hot water.

A toilet flapper will remain open when the chain that it is connected to is too short. The chain should lift the flapper just enough to allow it to open the rest of the way on its own. The chain should have just about half an inch of slack.