Top-rated toilet pros.

Get matched with top toilet pros in Cambridge, NE

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Cambridge, NE?

Select your specific project to find the pro for you.

Find Toilet pros in Cambridge

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Cambridge, NE and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"It went well. Although my toilet have started leaking again."
Recommended by81%of homeowners
Request Quote
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Cambridge, NE and surrounding areas

In business since 1971

Credit card accepted

"Fixed shower but stated Toilet not on work order but suggested remedy. To keep in mind: If you need more than one thing done, Be sure to specify on initial work order as they will only do what is on work order from AHS"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Request Quote
Burns Construction
0.0(
2
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Cambridge, NE and surrounding areas

In business since 2000

Free estimates

Burns Construction, is a full service general contracting firm operating in the greater SW NE area for many years. We pride ourselves in our attention to detail and our unsurpassed customer service. The quality of our work speaks for itself and we look forward to working with you on your next project.

Recommended by100%of homeowners
Request Quote
Toilets questions, answered by experts

The normal water level in a toilet bowl is about halfway full. The water should sit above the P trap drain because this creates a seal and suction. When you flush the toilet, the suction keeps sewer gases from entering your house through your toilet. Anytime the water level is higher or lower than half full, you need to make adjustments or replace broken parts.

Yes, you can install a basement bathroom without breaking concrete by using an upflush toilet system, which includes a macerator pump. These systems sit on top of the concrete floor, so you don't have to drill into it to install plumbing. The macerator pump breaks up waste until it is soft enough to pass through a discharge pipe to the main sewage line. This method saves you time and money by bypassing the need to break concrete to connect drain pipes.

If you’ve accessed the bolts and nuts that hold your toilet seat in place and can’t unscrew them, it’s possible that they were overtightened or that the material corroded over time, making it impossible to unscrew. If that’s the case, you can either call in a plumber for help, or you can DIY a solution if you’re careful. Lay down masking tape around the mounting bracket and then use the tape as a surface to lay a hack saw blade. Move slowly to cut through the bracket and bolt, being careful not to damage the porcelain in the process.

The most common toilet repair is dealing with clogs, followed closely by replacing a worn-out flapper. While clogs can happen anytime in any toilet, they most commonly occur with older toilets that have smaller diameter clearances and often empty into smaller diameter sewer connections. Because toilet flappers only last a few years, they are next in line for the most common toilet failures.

You can DIY your toilet flapper replacement if you’re up for a small plumbing project. Turn off the water to the toilet, open the tank lid, remove the chain from the lever, and unhook the flapper. For a new, adjustable flapper, adjust it to the right setting according to your toilet's gallons per flush rating. Hook the flapper in place and install the chain with 1/2 inch of slack.

The Cambridge, NE homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles