Get matched with top toilet pros in Grant, NE

Many parts of your plumbing system can fail, but clogged drains are one of the biggest plumbing problems you’ll likely encounter. From your kitchen sink, bathroom sink, or bathtub, there are plenty of opportunities for gunk, hair, food scraps, and more to get stuck in drains. When this happens, water will slowly drain, leading to standing water, bad odors, drain flies, and other issues.

Many homeowners can handle a minor clog themselves, but if you have a clog in your main line, you’re best off hiring a local plumber to get the drain back to its normal flow rate.

Your toilet handle might not come back up if the nut is loose or the bolt threads are stripped. Try to tighten the mounting nut and wrap plumber’s tape around the handle bolt to fix stripped threads. It’s possible the handle was improperly installed. If that’s the case, you can use the instructions above to correct the handle’s position. 

Yes, and no. Your shower, toilet, and sink all connect to the same main drain, but the secondary drains going from each fixture to the main drain are usually separate. This isn’t always the case—especially in older homes—but since toilets contain black water and showers, tubs, and sinks have grey water, toilets are more regulated and come at a greater risk of contamination. It’s best to keep these drains separate using individual waste collection for this reason.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.