Top-rated toilet pros.

Get matched with top toilet pros in Brady, NE

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Brady, NE?

Select your specific project to find the pro for you.

Find Toilet pros in Brady

Campbell Comfort Solutions - Mason City, Nebraska Facebook
New to Angi
Faucets, Fixtures and Pipes - Repair or Replace

Serving Brady, NE and surrounding areas

In business since 2016

Free estimates

We're dedicated to providing our clients with the very best in service, installation, and repair for all phases of your plumbing needs. We specialize in a variety of residential and commercial services and take pride in the attention to detail put into each of the projects we're involved with. We're known for our quality work and the integrity of our business. We look forward to building long-term relationships with our clients, and guarantee your satisfaction.

Burns Construction
0.0(
2
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Brady, NE and surrounding areas

In business since 2000

Free estimates

Burns Construction, is a full service general contracting firm operating in the greater SW NE area for many years. We pride ourselves in our attention to detail and our unsurpassed customer service. The quality of our work speaks for itself and we look forward to working with you on your next project.

Recommended by100%of homeowners
Toilets questions, answered by experts

Installation typically takes 1-2 hours. Repairs may require additional time, depending on the issue.

Start by gutting the old fixtures and features that need to be removed, such as the tile, vanity, and flooring. You may benefit by removing the toilet, even if you intend to use the same one. Next, install the new shower or tub, followed by the flooring, and then the drywall, which you should then paint. After that, install your new cabinets, vanity, countertop, sink, and faucet, in that order. Replace your light fixture next. Lastly, reconnect the toilet.

There are a few reasons why this could be the case. More than likely, your flapper is worn out and needs to be replaced. When it’s worn out, it lowers the water pressure during each flush leading to inefficient flushing. Luckily, replacing a toilet flapper is a simple repair that should only take about 30 minutes.

Yes, you can pour water down the toilet to help it flush. For each flush, you’ll need 1 to 2 gallons of water for newer toilets or 3 to 5 gallons of water for older toilets. Rather than dumping the entire bucket in all at once, pour the water in slowly for the best results. If you’re pouring water down the toilet to help it flush after a clog, only use 1 gallon of hot water.

Most codes require 15 inches on either side of the toilet's centerline (from the wall or vanity) and at least 21 to 24 inches between the toilet and the wall in front of it. These codes ensure that your toilet is easy to use and access, even in small bathrooms. Check your local building codes for the exact measurements required. 

The Brady, NE homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.