Best toilet pros near Columbus, NE

The normal water level in a toilet bowl is about halfway full. The water should sit above the P trap drain because this creates a seal and suction. When you flush the toilet, the suction keeps sewer gases from entering your house through your toilet. Anytime the water level is higher or lower than half full, you need to make adjustments or replace broken parts.

If you experience the telltale sign of wax ring failure, which is leaking water, replacing the faulty ring takes one to three hours, depending on accessibility. This is an exacting and time-consuming job, as several components must be removed for the plumber to access the ring. Once replaced, however, wax rings require little to no maintenance and last 30 years or longer.

The water in your toilet tank refills after each flush. So if you see dirty water in the bowl, you should check the tank to see if it’s coming from there. A dirty toilet tank can be the result of sediment in the water itself—-after all, the water will sit in the tank between flushes and can cause the interior to change into a dingy color. Faulty toilet components, like an old flapper, corroded tank lever or chain, or damaged seals, can also lead to dirty water as the materials break down inside the tank. You can clean the toilet tank or change out the old parts to give it a fresh start.

If you notice water leaking down the side of the bowl or tank and you don’t notice any cracks in the porcelain, the odds are that it’s condensation. If you notice water around the base of the toilet, this points to a leak. Check for loose bolts. A sewage odor may also indicate a broken toilet flange.