Get matched with top toilet pros in Genoa, NE

If a toilet is not properly vented, you could experience issues like poor drainage, slow flushing, frequent clogs, malfunctioning traps, gurgling noises, and the release of sewer gasses. If left untreated, all of these issues could lead to longer term structural damage or (in the case of sewer gasses) harmful health side effects.

This rumbling noise after flushing may sound like a hammer or knocking inside the walls. When you flush, it opens a valve so additional water can come in. However, if the valve malfunctions, then this rush of water has nowhere to go, which makes all the excess water hit your pipes and create a loud hammering sound.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

Toilet seats have two mounting brackets on the back that accept mounting bolts. The bolts drop through the brackets, through two small holes on the top of your toilet, and then receive nuts to hold them in place on the bottom of the toilet. If you can’t see the bolt heads, you might need to pry up the mounting bracket cover, which is a plastic piece that hides and protects the bolts.