Top-rated water softener pros.

Best water softener pros near Harvey, ND

Enter your zip and get matched with up to 5 pros

Need a pro for your water softener service project in Harvey, ND?

Select your specific project to find the pro for you.

Top-Rated Water softener pros in Harvey - Updated Nov 2026

FM Water Systems LLC
5.0(
2
)
Water Treatment & Purification System - Install or ReplaceWater Treatment & Purification System - Repair or Service

Serving Harvey, ND and surrounding areas

In business since 1991

Free estimates

Credit card accepted

FM Water Systems is your locally owned and operated authorized Kinetico Dealer with over 30 years of experience. We take great pride in our prompt response, expertise and superior customer service every time so call today! \n \nCommercial and Residential clients always welcome!

Response time3 days
Recommended by50%of homeowners
Water Softeners FAQs, answered by experts

Replacing a water softener costs $200 to $6,000, depending on the capacity of the water softener, the type of water softener, and the amount of people living in your home. An ion exchange water softener is the most common type and costs $500 to $3,000. Water distillers, which cost $1,200 to $4,000, and dual-tank models, which cost $1,000 to $5,000, are definitely pricey, but they offer more filtration or capacity, respectively.

Whether you need a permit or license for a water softener installation depends on your location, as requirements vary significantly. Some municipalities require the installer to hold a plumbing license, some mandate a permit and an inspection, and others require both. In some areas, no special permit or license is needed at all.

To determine the rules in your area, you can contact your local building department or consult a local water softener installer or plumber. Often, only certified professionals are authorized to pull the necessary permits, and they will typically handle the entire permitting process for you. Regardless of local laws, it is always recommended to hire a licensed professional to ensure the system is sized and installed correctly. You can use Angi’s state licensing tool to check an installer’s license status.

You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips. 

The process of inspecting your water softener system is similar.

Hard water isn’t necessarily bad for you. In some ways, it’s good for you. If you’re deficient in magnesium or calcium, hard water can give you a mineral boost that you wouldn’t get with soft water. However, this is where the benefits of hard water pretty much stop. Hard water can cause many minor inconveniences and lead to costly, premature replacements of your water-using appliances.

You should not use a water conditioner with a water softener because a water conditioner changes the chemistry of the water and causes the ion exchange in a softener to be ineffective. Choose a water softener if you have hard water or well water, and use a water conditioner if you need to remove certain contaminants.

The Harvey, ND homeowners’ guide to water softener services

From average costs to expert advice, get all the answers you need to get your job done.