Get matched with top toilet pros in Providence, NC

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

Some older homes have toilets in the basement to combat sewage backups. This type of toilet, also known as a Pittsburgh potty, acted as a safety valve over the incoming sewer line. If a line backed up, it would back up into the toilet because it was the lowest fixture in the home, keeping it out of sight and away from the finished areas of the house.

Basement toilets were also used by workers with messy jobs, like those who worked in coal mines or steel mills. This way, they could clean up and avoid tracking dirt through their home.

Yes, a bathroom remodel is a worthwhile home improvement project that typically adds value to your home, offering a return on investment (ROI) between 60% and 70%. Potential buyers look closely at bathrooms and kitchens, as these are often the most expensive rooms to renovate. A modern, updated bathroom is more appealing and assures buyers that the plumbing, fixtures, and flooring have a long, useful life ahead. Beyond the financial return, a remodel can also greatly increase your day-to-day satisfaction by creating a more inviting, spa-like space. Even a basic refresh with new paint and accessories can make a significant difference.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.