Top-rated toilet pros.

Get matched with top toilet pros in Elon, NC

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Elon, NC?

Select your specific project to find the pro for you.

TRUSTED BY ELON, NC HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon612
    Verified toilet services reviews

Find Toilet pros in Elon

Avatar for All Plumbing Services of the Triad, Inc.
All Plumbing Services of the Triad, Inc.
5.0(
17
)
Drain Clog or Blockage - Clear

Serving Elon, NC and surrounding areas

Approved

In business since 2002

Free estimates

Emergency services offered

"Returned from Christmas holiday on 01/02/23 and found pipes had burst from single digit temps and power blackout. Called All Plumbing and they came out to turn off water and later repaired pipes that were leaking and replaced valves that week. Pricing was reasonable and techs were very knowledgeable. I didn't feel I was getting ripped off because I had utilized their services two years prior replacing pipes underneath the house that were 60 years old. Highly recommended."
ADA toilet and waterless urinal by Kohler
Shower with body sprays  and hand held sprayer
Commercial grade kitchen sink faucet
Mop sink faucet
Low water consumption water closet by Kohler

+15

Response time3 hrs
Recommended by93%of homeowners
Avatar for Darryle Clark
Darryle Clark
New to Angi
Drain Clog or Blockage - Clear

Serving Elon, NC and surrounding areas

Approved

Small jobs welcome

Credit card accepted

My name is Darryle Clark. I’m originally from New Jersey, but stay in NC currently. I’m 31 years old with 5 years of plumbing experience. I’m a proud father of 3 and just looking to help those in need and support my family! Dedicated to quality service at no hassle to you.

...
Showing 1-10 of 111
Toilets questions, answered by experts

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

If you decide to replace the toilet flapper yourself, the only cost will be buying the new flapper for around $5 to $17. You can also hire a plumber or handyperson to take on the job instead, in which case you’ll pay an hourly rate for labor plus the cost of parts. Handypersons charge $50 to $150 per hour, while plumbers cost $45 to $200 per hour. This repair might take less than an hour for your pro, but note that many providers have a minimum rate for a house call. 

To drain a broken toilet, place towels or plastic sheeting around the base in case of splashing or overflowing. Next, shut off the toilet’s water supply, usually via a valve on the wall behind the toilet. Begin flushing the handle to remove as much water as possible from the tank and the bowl. Don’t flush the toilet if it’s clogged, though. From there, use a large sponge to soak up any remaining water and wring it over a bucket. 

You can DIY your toilet flapper replacement if you’re up for a small plumbing project. Turn off the water to the toilet, open the tank lid, remove the chain from the lever, and unhook the flapper. For a new, adjustable flapper, adjust it to the right setting according to your toilet's gallons per flush rating. Hook the flapper in place and install the chain with 1/2 inch of slack.

Technically, you can put an elongated toilet seat on a round toilet, but it’s not a good idea. Elongated toilet seats are a few inches longer than round toilets, so they will hang over the front edge of your toilet, which isn’t appealing. Additionally, an unsupported toilet seat or portion of a toilet seat is more likely to crack and shift, which could result in injury to whoever uses the toilet. Always match your toilet seat style to your toilet, or replace the toilet entirely if you’re looking to switch styles.

The Elon, NC homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.