Get matched with top roofers in Eastover, NC

An improperly installed skylight could potentially impact your roof's warranty. This happens because roofing penetration is necessary during skylight installation. Check your warranty information to verify. In most cases, having skylights professionally installed with proof that flashing is being done to specifications can be enough to preserve your roof's warranty.

Asphalt shingles have varying thicknesses across the length, so failing to stagger shingles from one row to the next will leave you with bulges and bumps if the thicker sections stack on top of each other. Not only is this unappealing, but it increases the risk of water intrusion. Stagger each new row by 6 inches to avoid this issue.

Yes, an underlayment is required for metal roofs, especially when installed over an indoor residential living space. This underlayment acts as a protective barrier between the metal roofing and the roof deck. Common materials include tar, asphalt felt, or woven synthetic polymers. Depending on local building codes, existing shingles in good condition may also suffice. A quality underlayment is crucial as it provides protection against water intrusion, improves energy efficiency through insulation, helps absorb sound, and ultimately extends the lifespan of your roof.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.