According to the National Electrical Code (NEC), GFCI outlets should be installed in wet or damp locations where they might be splashed with water or other liquids. This is to protect against ground faults, which are more common around water. Specific areas that require GFCI outlets include kitchens (especially near counters), bathrooms, laundry rooms, basements, garages, and all outdoor receptacles. Depending on local electrical codes, you may need at least one GFCI outlet in these rooms, or every outlet in the area may need to be GFCI protected.

You can use both LED and incandescent bulbs in an incandescent fixture as long as the bulb base is the right size. Never use a higher wattage than what the fixture recommends. However, it’s usually safe when transitioning to LED bulbs because they typically have a lower wattage than their incandescent counterparts.

Yes, you can convert a gas water heater to an electric one, but it is a complex process. You will need to ensure there is adequate power for the new electric unit, as they require more power than gas models. The project also involves safely closing off the gas lines and ventilation, and some cities may require a permit for the conversion. The cost can range from $1,500 to $4,100, depending on the installation scope, plumbing and electrical work, and the water heater model. For an accurate quote, it's best to contact a local professional. Also, be aware that your monthly utility bills may increase after the conversion, as natural gas is typically cheaper than electricity.

Yes, you can run an above-ground electrical conduit and stay within National Electrical Code safety guidelines. Just make sure you check the code requirements of your project with the local building regulations office. You should work with a local electrician to complete this type of project due to the personal safety hazards.