Get matched with top electricians in Worden, MT

It’s important to ask an electrician a few questions before you commit to hiring them so you can make an informed decision as a consumer. If you’re getting estimates or considering hiring an electrician, ask them these questions:

• Are you a full-time electrician?

• Are you bonded, licensed, and insured?

• What level of experience do you have as an electrician?

• Can you please share three references?

• Do you do residential or commercial electrical work?

• What kinds of electrical work are you most familiar with?

• Will any subcontractors be performing the work?

• Are permits and inspections required?

• Who is responsible for obtaining permits and inspections?

• What is your schedule?

• Do you offer a guarantee or warranty on your work?

• Will you sign a do-not-exceed clause to keep the job within the budget?

Yes, wire connectors are the better option for securing splices compared to electrical tape. It is not recommended to use electrical tape as it is not secure enough to keep the splices together. Plus, electrical tape is more vulnerable to damage, which can cause a risk of fire over time. 

To upgrade electrical systems in older homes, you might need to reroute new wires with lath and plaster walls. That’s because it’s more challenging to get inside the walls of an older home compared to a modern home, which usually uses drywall. But there are easier ways to level up your electrical game in an older home. For instance, you can swap out an old furnace for a new electric heat pump, or you could use a heat pump for water heating.

How far you can run underground electric depends on the wire gauge (generally AWG) and the circuit voltage. Too much voltage drop in an electrical circuit can negatively affect performance, so the smaller the voltage drop, the better. Ideally, it shouldn't exceed 3%. The smaller the wire and the longer the run, the more significant the voltage drop. 

For example, with a 120-volt circuit, you can run 60 feet of 12 AWG cable without losing more than 3% voltage. With a 240-volt circuit, you can run 120 feet of 12 AWG wire while maintaining a voltage drop of 3% or less.