Top-rated toilet pros.

Get matched with top toilet pros in Nesbit, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Nesbit, MS?

Select your specific project to find the pro for you.

TRUSTED BY NESBIT, MS HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon857
    Verified toilet services reviews

Find Toilet pros in Nesbit

Rustenhaven Services, LLC
New to Angi

Serving Nesbit, MS and surrounding areas

Approved

In business since 1995

Free estimates

Credit card accepted

We have over 30 years of experience in the industry. We are dedicated to providing our clients with the very best in service, installation, and repair to meet your plumbing needs. We take pride in the attention to detail put into each of the projects we're involved with. We're known for our quality work and the integrity of our business. We look forward to building long-term relationships with our clients and work hard to guarantee your satisfaction.\n

Closet collar repair
Mop Sink Service Faucet
Mop sink service faucet
Response time2 days
...
Showing 1-10 of 123
Toilets questions, answered by experts

You generally cannot replace a 10-inch rough-in toilet with a 12-inch model without making significant plumbing updates. A 12-inch rough-in toilet will not fit a 10-inch rough-in space because the floor drain is in the wrong position. To accommodate the larger toilet, you would need to move the drainpipe, which could cost between $0.75 and $30 per linear foot, plus labor. In most cases, it is more cost-effective and simpler to purchase a new 10-inch rough-in toilet. However, it is possible to install a 10-inch rough-in toilet in a 12-inch space by using a longer connector.

The cost depends on the parts, labor, extent of damage, and whether extensive plumbing modifications are required. Typical repairs cost $150-$300.

Yes, you can pour water down the toilet to help it flush. For each flush, you’ll need 1 to 2 gallons of water for newer toilets or 3 to 5 gallons of water for older toilets. Rather than dumping the entire bucket in all at once, pour the water in slowly for the best results. If you’re pouring water down the toilet to help it flush after a clog, only use 1 gallon of hot water.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

The Nesbit, MS homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.