Get matched with top roofers in Tipton, MO

Yes, it’s possible to replace drip edge flashing without removing shingles, but it’s not a good idea. You’ll have to lift the bottom shingles up to remove the old drip edge, install the new material, and then lay the lifted roofing material over the new drip edge. Bending roof shingles can cause damage, and if you have ongoing issues with roof leaks that prompt drip edge replacement, it’s a good idea to consider a roof and drip edge replacement to avoid ongoing issues.

Fall is widely considered the best time of year to replace a roof. The moderate temperatures are ideal for roofing crews to work and for new shingles to seal properly. Additionally, autumn weather is often drier, reducing the risk of weather-related delays compared to the rainier spring season.

While spring is also a viable option, the higher chance of rainfall can slow down the project. The main drawback to a fall installation is that it's the peak season for roofers, which can lead to higher prices and scheduling challenges.

To potentially save money, you could consider scheduling your roof replacement during the summer or winter off-seasons. However, both seasons have significant disadvantages. Extreme summer heat can make shingles too soft to handle, while winter's cold, snow, and ice can create dangerous working conditions and prevent shingles from sealing correctly, as they typically require temperatures above 40-45°F.

The most important thing to remember when laying shingles is to work from the bottom of the slope to the top. This leaves you with a top overlap that directs runoff from one row to the next until it reaches the eave for disposal. You should also make sure you follow the manufacturer's instructions and the local building code for nailing patterns and frequency so all of your hard work stays put through varying weather conditions.

Some people prefer to use connectors consisting of galvanized metal to replace the birdsmouth cuts on the rafter board. Common names for these metal pieces include hurricane ties and variable-pitch connectors. Making birdsmouth cuts is more cost-effective than purchasing these connectors for each rafter. However, because making large birdsmouth cuts to accommodate extra-wide exterior walls can weaken the rafter, a connector may be the better option in some cases.