If you need to run a wire from the meter to the breaker box, start by turning off the power using the main switch to avoid injury risks from live wires. Then, locate the ground wire from your meter and connect it to the ground bar of the breaker box. Connect the neutral wire using the same method to improve your circuit efficiency.

Next, locate the hot wires running from the main switch to the meter. To connect them to the correct terminals from meter to breaker, unscrew the nuts of the breaker hotwire terminals, insert the positive hotwire, and ensure it’s firmly attached. Finally, secure the wires with electrical tape and wire tie cables before re-securing your breaker box. Keep in mind that this process can be dangerous, so don’t hesitate to hire a local electrician.

Yes, tamper-resistant outlets are a safe and effective way to protect children from electrical hazards. They feature a spring-loaded shutter that blocks the outlet slots when not in use, preventing a child from inserting foreign objects. While they are the safest option available, it's important to note that few things can be considered truly 'childproof.' Children may still try to imitate adults by inserting a plug, so constant supervision around any electrical device is recommended. Tamper-resistant outlets are a much safer solution than childproofing covers, which can be removed by children and may pose a choking hazard.

You can run a small or basic standard-size refrigerator on a 15-amp circuit. But you should plug a modern, standard-size refrigerator into a 20-amp dedicated circuit. The refrigerator needs to be on a dedicated circuit, meaning it is the only appliance and outlet on that circuit breaker. This method prevents tripping the breaker and reduces the chance of an electrical fire. 

While washers and dryers do not require a GFCI (ground fault circuit interrupter) outlet to function properly, electrical codes often mandate their use for safety. The National Electrical Code (NEC) requires GFCI protection for all outlets within six feet of a water source. This means a washer and dryer must be plugged into a GFCI outlet if they are installed in locations like a laundry room, utility room, garage, or basement. In other areas without a nearby water source, there is no specific requirement, but using a GFCI outlet is still recommended for extra peace of mind. It is always best to consult your local codes and regulations to ensure compliance and safety.