Top-rated concrete resurfacing pros.

Get matched with top concrete resurfacing pros in Proctor, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete resurfacing project in Proctor, MN?

Select your specific project to find the pro for you.

Find Concrete resurfacing pros in Proctor

Graystone Concrete & Masonry, LLC
New to Angi
Concrete Flatwork - Repair & Resurface- For Business

Serving Proctor, MN and surrounding areas

In business since 2009

Free estimates

GrayStone Concrete & Masonry, LLC, is your 1st and finest choice in concrete and masonry, all right here in our community. GrayStone Concrete and Masonry, LLC, produces elegant concrete and masonry work. Producing the ultimate in quality craftsmanship, with pride in doing great work, we care for your place and your project, as if it was our own. We are your one-stop shop serving the complete project, even aspects not noticeable -- we allow the whole to be completed right when it should be. Rest assured and everything is good with GrayStone Concrete & Masonry, LLC. We are perfectionists and all of our work is guaranteed. Call now.

Showing 1-10 of 11
Concrete Resurfacing questions, answered by experts

In general, crack fillers last for about two years on average. That timeline can be shorter if you have extremely harsh winters or longer if you live in a mild climate. Luckily, this product is pretty affordable at the hardware store (about $10 to $30) and easy to DIY, so redoing it every few years shouldn’t be too much of a hassle.

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

The best solution to fix a foundation crack in your basement floor depends on the underlying cause. If you just have hairline cracks from settlements that are no longer growing, the best option is to seal them with a crack sealant. If the cracks continue to grow, one edge rises above the other, or there are signs that water is getting in through the crack, a professional repair will be necessary. Depending on the root cause, your professional may employ foundation underpinning or some other type of stabilization, seal the cracks, or install a drainage system.

How often you should resurface your pool deck depends on its material and condition. Concrete pool decks should be resurfaced every two to five years. Decks that are exposed to harsh heat and UV light may need to be sealed more often than ones that are mostly shaded.

The method used to repair cracks in your concrete driveway will depend on the extent of the damage, but the most common method for small cracks is to use a driveway resurfacing compound. This solution is either cementitious or made of polyurethane, and it will seal the crack and make your driveway appear undamaged. 

For more severe cracks, you will likely need to hire a professional driveway repair service. They can use mudjacking, epoxy injections, partial driveway replacements, or a combination of these to fix more serious cracks in your concrete driveway and to prevent recurring issues.

The Proctor, MN homeowners’ guide to concrete resurfacing

From average costs to expert advice, get all the answers you need to get your job done.