Get matched with top water softener pros in Marshall, MN

It depends on the type of surface. For instance, if you’re trying to get rid of hard water deposits on glass, you can spray vinegar onto the surface and wipe it off with a soft cloth or non-abrasive sponge. However, if the deposits are on granite or natural stone, it’s better to use baking soda and water rather than vinegar or other acidic cleaners.

No. You should never directly drain a water softener into a sewer cleanout. This practice is illegal in many areas because it could allow raw sewage to get into your drinking water and make you seriously ill. Many places have codes requiring a specific seal, pipe, and a large air gap between a water softener and a sewage cleanout. Check out Florida's Plumbing Building Code as an example of what these restrictions might look like.

Yes. To get soft water, you can install a water softening system, which will replace the calcium and magnesium ions in the water with sodium or potassium ions. Water softeners cost anywhere from $200 to $6,000, depending on the size and complexity of the system. You can either install a water softener for the whole house or just at your shower heads. If you’re sensitive to sodium or potassium, you can install a salt-free water conditioner.

You can use a commercial water repellent treatment for glass on your shower doors to prevent water spots. Take care to only apply the product to glass. Letting air circulate also helps prevent water spots, as water is less likely to remain on the glass for a long time with good air circulation. Run your vent fan, open a window, and leave the shower door open for about half an hour after using the shower.