Get matched with top plumbers in Askov, MN

The cost to unclog a drain varies based on the location and severity of the clog. For simple clogs within your home, such as in a sink, toilet, or shower, hiring a plumber typically costs between $110 and $350, with an average of around $200. Snaking a toilet or sink usually costs between $110 and $275, while a bathtub or shower clog costs about $225.

For a more serious clog in the main sewer line, the cost is higher. Clearing a main line clog generally costs between $200 and $600, with an average of about $380. However, prices can range from as low as $100 for snaking a minor clog to over $1,600, particularly if advanced methods like video inspection and hydrojetting are needed for a large or hard-to-reach blockage. Some severe main line clogs can cost upwards of $1,000 to clear depending on factors like the cause of the clog, its distance from an accessible cleanout, and whether the pipe is located beneath an occupied space (e.g., in an apartment building). You may be able to save money on minor clogs by using a drain snake or bladder yourself.

There are three main types of shower valves: pressure-balancing, thermostatic, and diverter. Pressure-balancing and thermostatic valves are both considered mixing valves because they regulate water flow and temperature, but they do so in different ways. A pressure-balancing valve senses changes in water pressure, such as from a flushing toilet, and adjusts the incoming hot and cold water to maintain a consistent temperature; these typically use a single knob. A thermostatic valve uses a thermostat to precisely control the water temperature and requires a separate control to adjust the water volume. A diverter valve directs the flow of water from one fixture to another, such as switching from a tub faucet to a showerhead in a tub-shower combination.

Plumbers typically install and run gas lines. While most qualified local plumbers can handle this job, you might consider hiring a natural gas line plumber who specializes in this work. Before starting any project, it's best to check with your local utility company. They can offer recommendations for licensed plumbers who are authorized to pull permits and ensure the installation is done correctly. Regardless of who you hire, always verify that they have the proper licenses and credentials for working with gas lines.

Your toilet handle might not come back up if the nut is loose or the bolt threads are stripped. Try to tighten the mounting nut and wrap plumber’s tape around the handle bolt to fix stripped threads. It’s possible the handle was improperly installed. If that’s the case, you can use the instructions above to correct the handle’s position.