Top-rated contractors.

Get matched with top contractors in Ludington, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Ludington, MI?

Select your specific project to find the pro for you.

Find Contractors in Ludington

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Ludington, MI and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Andrew Edmondson
Andrew Edmondson
3.7(
33
)
Major Home Repairs (General Contractor)

Serving Ludington, MI and surrounding areas

In business since 2008

Free estimates

Emergency services offered

"After Andrew built the ramp and deck extensions off of our existing decks in the spring of 2015, we hired him in May 2016 to clean, seal and stain the decks and ramp. We had concerns about drips and splatter onto the house and areas below the decks. Andrew eased our concerns and assured us he would tarp everything off and put plastic on the house to prevent and splatter and drips. Everything turned out great and there were no drips or splatter! Andrew's communication and professionalism were fantastic throughout all phases of the project. We highly recommend Andrew and his team."
Response time2 days
Recommended by86%of homeowners
Joe S Kutchinski builders
New to Angi
Major Home Repairs (General Contractor)

Serving Ludington, MI and surrounding areas

Free estimates

Warranties offered

Small jobs welcome

I was born and raised in lake county, october nineteen sixty four. My father was a contractor in the 60s through 2015. I also had an uncle that was a contractor here in Lake County and an uncle. That is a contractor up in Traverse City. I worked with all of them from the 70s on. Mostly worked for my dad until 1988 when I got my residential builders license. Working here in Lake County, you had to learn to do all of the jobs yourself. You had to learn to do concrete, foundations, lay blocks, framing, build rafters, do roofing shingles or metal roofing. Set windows do siding. Build additions, garages, pole barn, porches, decks, sheds. Do installation, drywall, finished trim.\nFlooring ceramic, tile hardwood floors, laminate flooring. Do trim work ect. I do have subcontractors that I work with. I did the remodel job on the dial a ride building in lake county. I did the Idlewild welcome signs on US 10. I worked with Habitat for Humanity.\nFor the last 8 years. Hopefully hope we can do busi\n\n

Showing 1-10 of 20
Unfinished Carpentry questions, answered by experts

Yes, you will need a jack for a rim joist replacement. To prevent sagging and facilitate the removal of load-bearing wood, you’ll need to relieve the pressure from this joint before beginning work. 

Due to hydraulics and other specialized equipment, a sill plate and rim joist replacement are not typically a DIY project. Hiring a professional structural engineer and experienced contractors is the best approach to replacing rotted sill plates and rim joists.

Installing a tongue-and-groove wall requires similar techniques to those associated with installing shiplap. However, because of the precision necessary to make each board fit perfectly and the increased material prices, the cost is higher than that of shiplap installations. Expect to spend between $2 and $6 more per square foot for tongue-and-groove walls versus shiplap ones.

Metal stud framing parts include the studs themselves, upper and lower tracks that act as top and bottom wall plates, various angle fasteners and clips, screws for fastening pieces togeher, metal straps, c-channel supports, and thicker steel supporting structures. Roof framing metal components include pre-fabricated trusses, heavy-gauge stud pieces, and various plates and fasteners.

Bow windows need support because they are large and extend out from the exterior wall of the home. Bow windows may extend 1 foot to several feet from the outside of the home, so you’ll need to provide additional support to handle this weight. A window contractor will be able to provide the proper amount of support for your new bow window.

Framing most homes takes anywhere between five and eight weeks to complete. You’ll need to account for inclement weather conditions, material shipment times, the number of crew members, and the weight of your materials. If the weather is too hot, wet, or cold for the installation, this process could take closer to eight weeks.

The Ludington, MI homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.