Get matched with top garage cleaning pros in Ishpeming, MI

Getting a garage door tune-up is worth it. Tune-ups are a form of preventative maintenance that help extend a garage door's lifespan and prevent dangerous issues, like worn springs or misaligned sensors. The cost to get a garage tune-up is far less than letting problems get out of hand and causing costly repairs—or worse—injuries.

No, there should not be a gap between your garage door and the floor. Gaps can make your garage less energy efficient, leading to higher energy bills. They also create an entry point for pests like rodents and insects, as well as rain and melted snow, which can lead to foundation damage or mold issues.

If you have a gap under your garage door, potential causes include an uneven garage floor or worn-out weather stripping. To fix it, you can try several solutions:

• Replace the weather stripping: The seal at the bottom of the door may need to be replaced.

• Adjust the garage door: You may be able to adjust the closing position on your garage door opener to eliminate the gap.

• Inspect the floor: If the concrete floor has shifted or is uneven, it may need to be repaired to create a level surface.

If these solutions do not resolve the issue, it is best to call a garage door repair specialist to inspect the door and floor.

During a garage door tune-up, a pro will check and adjust your door’s components, looking for any damage and loose cables, springs, or rollers. The pro will also lubricate moving parts, like the hinges and rollers, and likely tighten some screws and bolts. They’ll also adjust the door opener’s tension and alignment to make sure it’s level. Finally, they’ll wash the door to ensure it’s clean, and test the auto-reverse mechanism to make sure it’s working as it should.

If you take caution around fragile garage parts, thawing methods shouldn’t cause problems. Avoid using direct sources of heat too close to the garage door, especially rubber parts.

Another spot to avoid heating is the garage door spring. This powerful metal spring can become very cold in winter. Applying heat to a cold spring increases the chances it could break.