Get matched with top roofers in Dryden, MI

The most common defect in a flat roof is leaking. Flat roofs have minimal slope, so water pools more readily on a flat roof than on a sloped roof, and the risk of the waterproof membrane failing increases with exposure. Tears and punctures from foot traffic and blown debris are other common problems, especially with single-ply roofing membranes like TPO and EPDM roofs.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

No, cool roofs are not suitable for all climates. Cool roofs are very good at reflecting solar heat, so they’re suitable for homes in warm or hot climates. However, they’re not good at retaining heat, so they’re not suitable for homes in cold climates.

A roof's ability to handle snow depends on its strength and the snow's weight, as wet snow is much heavier than dry, fluffy snow. While designs in snowy regions often allow for 35 to 50 pounds per square foot, a general guideline is that a typical roof can withstand about four feet of fresh snow, two feet of packed snow, or just one inch of ice. Factors like the roof's age, slope, and support structure also affect its capacity; newer, sloped roofs generally hold more weight than older, flat ones. Ice and ice dams add significant, dangerous weight. Because capacity varies, it is best to contact a professional roofing contractor or the original builder to determine the maximum snow load for your specific home.