Get matched with top door pros in Commerce, MI

French doors can either open inward or outward, but because hinges are the mechanism for opening and closing, a single set of French doors will not be able to do both. Most French doors only open outward onto a patio, deck, or porch, while some only open inward if the outdoor space is limited and can’t accommodate the open doors.

Residential exterior doors should swing inward. While this cuts into your living space and prevents you from putting furniture near the inside of your door, it also means that the hinges will only be accessible from the interior. Hinges that sit on the outside of your home leave your property far less secure, as someone looking to get in could simply unscrew them and remove your door. Additionally, inswing exterior doors will be operable even if you have snow or other obstructions outside.

WD-40 can be used on squeaky door hinges, but it is generally considered a temporary, short-term solution rather than a long-term fix. While it can silence a squeak in a pinch by breaking down rust and grime, it is not a true lubricant, as it contains only a small amount of lubricating oil that evaporates quickly. Using WD-40 alone may lead to the squeak returning and can attract dirt and dust, potentially causing more wear on the hinge over time. For a more effective and lasting solution, it is recommended to first use WD-40 to clean the hinge, then wipe it clean. Afterward, apply a dedicated lubricant such as silicone spray, white lithium grease, a metal or plastic lubricant, or an oil-based product like petroleum jelly.

Standard door sizes aren’t one-size-fits-all, but there are common go-to dimensions. For exterior doors—like your front door—36 inches wide by 80 inches tall is typical, though you’ll see 30- or 32-inch widths too, especially in older homes. Interior doors vary more. Bedrooms and bathrooms often use 30- to 32-inch widths, and closet doors can be anything from slim singles to wide bi-folds. Height is usually 80 inches across the board; however, always measure your actual opening. “Standard” only works if it matches what’s already in place.